21 treston.us | 800-437-6772 TRESTON LAB BENCHES Tools needed for Concept frame assembly: • 19 mm wrench • 13 mm wrench • 5 mm allen wrench • #2 Phillips head screwdriver Tools needed for Cornerstone frame assembly: • 10 mm wrench • 8 mm allen wrench Concept Manual A E F J I G K, K1 C D H B 24" x 48" 30" x 48" 24" x 60" 30" x 60" 24" x 72" 30" x 72" A 47.24" 47.24" 59.06" 59.06" 70.86" 70.86" B 22.50" 28.41" 22.50" 28.41" 22.50" 28.41" C 40.67" 40.67" 52.49" 52.49" 64.33" 64.33" D 40.10" 40.10" 51.90" 51.90" 63.71" 63.71" E 17.78" 23.69" 17.78" 23.69" 17.78" 23.69" F 11.42" G 23.33" 29.45" 24.33" 29.45" 24.33" 29.45" H 17.57" I 11.13" J 25.82"-43.34" K 5.59" *K 2.87" *K - Low Profile caster option • Concept worktable frame consist of a pair of legs, rear case, and front rail. • Depth of Concept table frame is 23.62", 29.5” or 35.43” with the use of depth kit. • Concept frames are available in widths: 39.37“, 47.24”, 59.05”, 70.86” and 78.74 • Leg pair Concept 30 can support 1100 lb load, evenly loaded. • Concept can be equipped with tilting mechanism. The tilting frame is for width 59.05”. Tilting frame is equipped with motor, which can tilt 85 lb load. Maximum tilting angle is 50 degrees. • Height adjustment of Concept frame is 25.82"-43.34" with adjustment glide. Height adjustment is made by adjusting telescoping legs and tightening friction screws on the back and sides of the legs. • Table frames can be easily equipped with any 12mm stem caster. Steel Thickness: Steels used in the construction of the frames are 12, 14 and 16 gauge CRS steel, except as follows: • Leg attachment parts: 7 gauge CRS steel • Cable rail: 20 gauge CRS steel Recommended table top assembly: • Treston laminate tops assembled with wood screws provided • Treston phenolic tops can be assembled in 2 ways: - Mechanical fasteners (screws) - Pre-drill a pilot hole in the bottom of the work surface, taking care to keep from penetrating through the top. The pre-drilled hole should be the same length as the screw shaft. The screw should be slightly larger in diameter than the pilot hole. Use a coarse threaded screw, wood or machine. - Adhesive - Use 100% silicon. Apply several “spots” or a continuous bead to the top of the table frame. Position the work surface as centered on the frame and let cure for 12 hrs at room temp.
RkJQdWJsaXNoZXIy NDk0Mw==